Installing The Stand (Optional) - ViewSonic CDE6502 User Manual

1.7.

Installing the stand (Optional)

If the stand is provided, please read these instructions thoroughly before attempting this installation.
CAUTIONS:
• Make sure that you handle your Display very carefully when attempting assembly or removal of the stand.
If you are not sure of your ability to do this, or of your ability to use the tools necessary to complete this
job, refer to a professional installer or service personnel. The manufacturer is not responsible for any
damages or injuries that occur due to mishandling or improper assembly.
• When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or
covering to prevent accidental scratching or damage to your Display's finish.
• Before attempting assembly or removal of the stand, unplug the AC power cord.
To install the stand:
Display
NOTES:
• The appearance of this product in these illustrations may differ from your actual product, and is for
comparative purposes only.
• We may change the design and specifications without notice.
1. Remove the stand from the box and place it on a table or
2. Lay your display flat (screen down) on the edge of a table or
Secure with four
3. Put the stand column close to the back of the display, align the
screws (M8X15)
Stand
3
bench.
You must pay attention to the direction of the stand. The wide
portion of the stand should go towards the front of the display.
bench. Make sure that you put down a soft cushion or cloth so
that your display is not scratched.
screw holes on the stand column with the holes in the display,
then secure the stand to the display with four provided screws.