Crossover Settings; Connection Via Speaker Leads; Speaker Size; X ‘ Over (Crossover) - JVC KD-R881BT Instruction Manual

AUDIO SETTINGS

Connection via speaker leads

For connections without using an external amplifier. However,
with this settings you can also enjoy the subwoofer output.
( 31)
Audio signal through rear speaker lead
Setting on
[SPK/PRE OUT]
L (left)
REAR/REAR Rear speakers output
REAR/SUB.W Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [120HZ] is selected in [SUBWOOFER LPF] and [THROUGH] is not
available.
– [POSITION R02] is selected in [FADER] and selectable range is
[POSITION R15] to [POSITION 00].
20
ENGLISH

Crossover settings

Below are the available setting items for 2-way crossover and 3-way crossover.
Caution
Select a crossover type according to how the speakers are connected. ( 31)
If you select a wrong type:
• The speakers may damage.
R (right)
• The output sound level may be extremely high or low.
Rear speakers output

SPEAKER SIZE

Rear speakers output
Selects according to the connected speaker size for optimum performance.
(Mute)
• The frequency and slope settings are automatically set for the crossover of the
selected speaker.
• When 2-way crossover is selected, if [NONE] is selected for [TWEETER] of [FRONT],
[REAR] and [SUBWOOFER] for [SPEAKER SIZE], the [X ' OVER] setting of the selected
speaker is not available.
• When 3-way crossover is selected, if [NONE] is selected for [WOOFER] of [SPEAKER SIZE],
the [X ' OVER] setting of [WOOFER] is not available.
X ' OVER (crossover)
• [FRQ]/[F-HPF FRQ]/[R-HPF FRQ]/[SW LPF FRQ]/[HPF FRQ]/[LPF FRQ]: Adjusts the crossover
frequency for the selected speakers (high pass filter or low pass filter).
If [THROUGH] is selected, all signals are sent to the selected speakers.
• [SLOPE]/[F-HPF SLOPE]/[R-HPF SLOPE]/[SW LPF SLOPE]/[HPF SLOPE]/[LPF SLOPE]: Adjusts the
crossover slope.
Selectable only if a setting other than [THROUGH] is selected for the crossover
frequency.
• [SW LPF PHASE]/[PHASE]: Selects the phase of the speaker output to be in line with
the other speaker output.
• [GAIN LEFT]/[GAIN RIGHT]/[F-HPF GAIN]/[R-HPF GAIN]/[SW LPF GAIN]/[GAIN]: Adjusts the
output volume of the selected speaker.