Table of Contents
Advertisement
1. Using the template provided and a
spirit level, mark the locations of the 2
upper fixing holes with a pencil.
3. Insert the 2 screws, leaving
approximately 5mm proud of the wall.
5. Mark a third hole when the fire is
mounted. Remove the fire, drill hole
and insert the wall plug.
Replace the fire and insert the third
screw to secure.
UNINSTALL
To uninstall, switch the controls to 'OFF', unplug the unit from the socket, remove the
lower fixing screw and lift the unit to unhook it from the screws securing it to the wall.
0 8
2. For solid walls, drill the 2 marked holes
using a 6.25mm drill bit, then fit the
supplied wall plugs.
Note: if fitting to plaster board,
propriety wall fixings should be used
(not supplied)
6mm
4. Hang the fire on the hooks situated
at the back of the fire
6. Place the pebbles on to the
fuelbed.*
Reattach the fascia.
Note: refer to the 'Attaching and
removing the fascia' information on
page 9.
*fuelbeds may vary
Advertisement
Table of Contents
