Table of Contents
Advertisement
SAFETY CUT-OUT DEVICE
To ensure against the potential hazard caused by blockage of the air outlet, this unit is
equipped with an automatic over-temperature safety cut-out device. When the device is
activated the heater will not operate. If this occurs, the unit can be reset using the
following procedure.
1.
Turn the fire off by depressing the on/off switch on the unit.
2.
Unplug the power cord form the electrical mains supply socket and leave
it disconnected for at least 10 minutes.
3.
Ensure that the air vents are free from obstruction.
4.
Plug the power cord back in to the mains socket.
5.
Turn the fire back on.
6.
If the heater fails to operate, check the fuse in the plug.
7.
If the fuse in the plug is ok and the fire is still not functioning, contact a
qualified service person.
TROUBLE SHOOTING
Symptom
The fire will not turn on.
No heat.
Heater operates and then the
heat cuts out.
Potential cause
Mains plug is not plugged in.
The On/Off switch has not
been switched on.
The Fuse in the plug has blown.
One or both of the heat
selector switches have not
been switched on.
The safety cut-out may have
operated.
Corrective action
Check the mains socket to
ensure the plug has been
inserted correctly.
Switch on using the operation
switches.
Check and change the fuse in
the plug.
Ensure that the heat selection
switches have been correctly
switched on.
Follow the procedures as
outlined in the "Safety cut-out
device" section.
1 3
Advertisement
Table of Contents
