Hardware Overview; Front Panel - D-Link DVG-2032S Quick Installation Manual

Hardware Overview

Front Panel

WAN Port
WAN LED
LAN Port
LAN LED
Reset
Power LED
Run LED
Alarm LED
Phone LEDs
(1-32)
Connects to your broadband modem using an Ethernet
cable.
When a connection is established, the 10 or 100 LED will
light up. The LED will blink to indicate activity. If the 10 or
100 LED does not light up when a cable is connected,
verify the cable connections and make sure your devices
are powered on.
Connect to an Ethernet enabled computer using
Ethernet cabling.
When a connection is established, the 10 or 100 LED
will light up. The LED will blink to indicate activity. If the
10 or 100 LED does not light up when a cable is
connected, verify the cable connections and make sure
your devices are powered on.
This button is used to reset the unit to its factory default
settings.
Indicates the unit is powered on.
The Run LED will flash during the self-test/boot process
and light green if the self-test or boot fails.
The Alarm LED will light red if the self-test or boot fails.
The Alarm will flash red while the system is registering or
if registration fails.
These LEDs display the VoIP status and Hook activity
on the phone ports that are used to connect normal
telephones. If a phone connected to a phone port is off
hook or in use, this LED will light up. When a phone is
ringing, the indicator will blink.
2