Adjusting The Discharge-Chute Latch; Replacing The Drive Belts - Toro 37781 Operator's Manual

1. 0.76 mm (0.030 inch)
5. Install the new spark plug, tighten it firmly, and attach
the ignition wire to the spark plug.
Note: Ensure that the ignition wire snaps completely
into place on the spark plug.
Adjusting the Discharge-Chute
Latch
If the discharge chute does not lock into the desired position
or does not unlock so that you can move it to another
position, adjust the discharge-chute latch.
1. Loosen the clamp fastener on the chute-support plate
until the cable is free.
1. Cable conduit
2. Cable clamp
2. Remove any slack in the cable by pulling the cable
conduit rearward.
3. Tighten the clamp fastener while holding the cable in
place.
Figure 45
g019021
Figure 46
3. Clamp fastener

Replacing the Drive Belts

If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged, have an
Authorized Service Dealer replace the belt.
1
2
3
23