Shutting Off The Engine - Toro 37781 Operator's Manual

Figure 23
1. Electric-start button
2. Electric-start plug-in
To use the electric starter (electric start only), connect a
power cord to the electric-start plug-in first and then
to a ground fault circuit interrupter (GFCI) power
outlet. Use only a UL-listed, 16-gauge power cord
recommended for outdoor use that is not longer than
15 m (50 ft).
Important: Do not use a worn or damaged power
cord.
WARNING
The electrical cord can become damaged,
causing a shock or fire.
Thoroughly inspect the electrical cord before
using the machine. If the cord is damaged,
do not operate the machine. Replace or repair
the damaged cord immediately. Contact an
Authorized Service Dealer for assistance.
Important: To prevent damaging the electric
starter, run it in short cycles (5 seconds on,
5 seconds off), no more than 10 times. If the
engine still does not start, take the machine to an
Authorized Service Dealer for service.
8. Disconnect the power cord from the power outlet first
and then from the machine (electric start only).
9. Allow the engine to warm up; gradually move the
choke toward the R
UN
run smoothly before each choke adjustment.
CAUTION
If you leave the machine plugged into a
power outlet, someone can inadvertently start
the machine and injure people or damage
property.
Unplug the power cord whenever you are not
starting the machine.
g019055
3. Recoil-start handle
position. Wait for the engine to

Shutting Off the Engine

1. Move the throttle to the S
the S position
TOP
You can also shut off the engine by pulling the ignition
key outward to the middle position.
2. Wait for all moving parts to stop before leaving the
operating position.
3. Remove the ignition key to prevent accidental starting.
4. Close the fuel-shutoff valve by rotating it clockwise
(Figure 25).
5. Pull the recoil-start handle 3 or 4 times.
Note: This helps prevent the recoil starter from
freezing up.
14
position, and then to
LOW
(Figure 24) to shut off the engine.
G016505
Figure 24
G016499
Figure 25