Checking And Adjusting The Traction Cable; Checking And Adjusting The Auger/Impeller Cable - Toro 37781 Operator's Manual

Checking and Adjusting the
Traction Cable
Service Interval: After the first 2 hours—Inspect the
traction cable and adjust it if necessary.
Yearly—Inspect the traction cable and adjust or
replace it if necessary.
If the machine does not drive in the forward or reverse speeds
or it drives when you release the traction lever, adjust the
traction cable.
If the left (traction) cable is not properly adjusted, do the
following steps:
1. Loosen the jam nut.
2. Engage the traction lever and hold it in place
34).
3. Loosen or tighten the turnbuckle to adjust spring
length to 5.5 cm (2.18 inches) as shown in
1. Jam nut
2. Turnbuckle
Figure 34
Figure
Figure 35
3. Spring
4. 5.5 cm (2.18 inches)
4. Tighten the jam nut
tension on the cable.
5. If the traction cable is properly adjusted but a problem
remains, contact an Authorized Service Dealer.
Checking and Adjusting the
Auger/Impeller Cable
Service Interval: After the first 2 hours—Inspect the
Yearly—Inspect the auger/impeller cable and adjust
or replace it if necessary.
1. Loosen the jam nut.
(Figure
2. Engage the auger/impeller lever and hold it in place
(Figure
3. Loosen or tighten the turnbuckle to adjust the spring
length to 7 cm (2.75 inches) as shown in
35.
1. Jam nut
2. Turnbuckle
4. Tighten the jam nut
tension on the cable.
20
(Figure 35), ensuring there is slight
auger/impeller cable and adjust it if
necessary.
36).
Figure 36
Figure 37
3. Spring
4. 7 cm (2.75 inches)
(Figure 37), ensuring there is slight
Figure 37.