Table of Contents
Advertisement
01GB01COV.book Page 16 Wednesday, November 19, 2008 5:04 PM
6.1.1 Easy registration
Insert the unregistered handset into
the base station to automatically
begin registration.
Registering... is displayed on the
screen.
• Upon successful registration, a
validation tone is emitted and the
handset number (1 to 8) will be
assigned by the base
automatically.
6.1.2 Manual registration
Power on the handset.
On the base station, press and hold
for 3 seconds. A beep sounds to
indicate that the base station is
ready to accept registration. (No
beep sounds on the SE650.)
Note
If no action is taken on the handset
within 90 seconds, the registration
procedure will be aborted. If this
happens, repeat from Step 1.
On the handset, press
to Advanced Set and press
Select.
Scroll
to Register and press
Select.
Enter the PIN when prompted and
press
OK to confirm.
Registering... is displayed on the
screen.
• Upon successful registration, a
validation tone is emitted and the
handset number (1 to 8) is
assigned by the base station
automatically.
16
6.2
Checking the signal strength
When you power on the registered
handset, the display will show the word
"Searching" and the Antenna icon
flashes until the handset locks onto its
subscribed base. Then the display shows
the standby display.
7
Using the Handset
7.1
Make a call
7.1.1 Predialing
Enter the number (maximum 24 digits)
and then press
7.1.2 Direct dialing
Press
or
, scroll
number.
7.2
Answer a call
When the phone rings, press
7.3
End a call
To end a conversation, press
or
.
and then dial the
or
.
.
Using the Handset
Advertisement
Table of Contents
