Cisco Asr 903 Aggregation Services Router Hardware Installation Guide - Cisco ASR 903 Hardware Installation Manual

Installing the Cisco ASR 903 Router
• Lugs fork-type or ring-type (Burndy, see Manufactures)—TP10 -6 or TP10-8F (recommended)
Step 1 Follow the steps to remove the power supply unit if installed in the chassis. See
Supply.
Step 2
Locate the T-shaped terminal block plug on the DC power supply unit. See the figure below.
Figure 67: DC PSU (A900-PWR550-D-E) with T-Shaped Connector
1
Step 3 Use a wire-stripping tool to strip the ends of each of the two wires coming from the DC-input power source to 0.27 inch
(6.6 mm) ± 0.02 inch (0.5 mm) and the wire for grounding. Do not strip more than 0.29 inch (7.4 mm) of insulation from
T-shaped connector

Cisco ASR 903 Aggregation Services Router Hardware Installation Guide

Installing the DC Power Supply
Removing and Replacing the DC Power
—
109