Selecting Fuse - Agilent Technologies 8453 Operator's Manual

WAR NI N G
WAR NU N G
CU IDA DO
AT T E N T IO N
AT T E N Z IO NE
1 Insert the tip of a small screwdriver under the slot on selector cover and lift
Installing Your Controller
Setting Up Your Control Unit

Selecting Fuse

The line fuse (primary fuse) is behind the voltage selector cover. If you
changed the line-voltage setting check that the correct fuse is installed for the
voltage operation you selected.
Ensure that the line-power cord is disconnected before installing or
replacing a fuse.
Stellen Sie sicher, daß der Netzstecker gezogen ist, bevor Sie eine
Sicherung einlegen oder ersetzen.
Asegúrese de que el cable de red está desconectado antes de colocar o
reemplazar un fusible.
Assurez vous d'avoir déconnecté le câble secteur avant d'installer ou
de remplacer un fusible.
Assicurarsi che l'alimentazione elettrica sia scollegata prima di
cambiare o inserire un fusibile.
See Table 4 for the part numbers.
There are two line fuses located together, only one of which is used. To
change a fuse:
up the cover to access the fuse.
30