Non-Flush Cut - Agilent Technologies 8712ET User Manual
Option 100 fault location and structural
return loss measurements
rf network analyzers
Hide thumbs
Also See for 8712ET:
- Programmer's manual (320 pages) ,
- User's handbook supplement (158 pages)
Table of Contents
Advertisement
Cable Preparation
Cable Preparation Problems
Non-Flush Cut
Cables which require a flush cut, such as for GTC-XXX-TX-N ("Pogo")
connectors, might not actually be cut in such a way. This can cause an
inconsistent connection or poor repeatability of the SRL measurement.
See
Figure 2-9
and
Figure
2-10.
Figure 2-9
Cable Cut Flush (good) and Non-Flush (bad)
Option 100 Fault Location and SRL
2-11
- Quick Links:
- Calibrate the Analyzer
Hide quick links:
Advertisement
Table of Contents
