Listening To Tape - Goodmans 4214 Instruction Manual

4. Press the MEMORY Button once again, the selected disc and track number is then
stored in memory. The CD Display will change to Program edit and 0 0 P-01.
5. Repeat steps 2 - 4 to enter additional tracks. You can store upto 40 programs in
memory. The CD Display will display "FULL" when 40 programs have been stored.
Notes:
LISTENING TO PROGRAMMED TRACKS
Program your selection of tracks by following the procedure shown above.
Press the PLAY/PAUSE Button.
Disc play will start at the beginning of the first programmed track.
TO CLEAR THE PROGRAM MEMORY
If the disc is playing, press the STOP Button.
Press the STOP Button again. The programme will then be erased from memory.
The programme memory will also be cleared if a different source is selected, or if the
power is switched off.
I
NTRO
Press the INTRO Key (on remote control only) and only, the first 10 seconds of each song
will be played.
L
ISTENING TO
INSERTION AND REMOVAL OF CASSETTES
m
Press the Stop/Eject Button to open the Cassette Door.
m
Slide the cassette tape into the cassette door with the exposed section of tape at
the bottom and the side to be played facing the front.
m
Close the Cassette Door securely before starting.
m
When finished, press the Stop/Eject Key to open the Cassette Door, and remove
the cassette tape.
If the PLAY/PAUSE Button is pressed before the MEMORY Button is
pressed to store a track, the track will not be programmed, and the disc
will start playing from the first selected track.
Any track can be programmed to play more than once.
If you press the STOP Button during MEMORY mode, the entire program
will be erased from memory.
T
APE
- 12 -