Initial Operation Of The Unit; Inserting The Battery; Charging The Battery - cyclotest myWay Instructions For Use Manual

Initial Operation of the Unit

Inserting the battery

Charging the battery

The battery is supplied partially charged. Charge the battery as described in the following before using
the unit for the first time. The battery reaches its full performance capability only after several com-
plete charging and discharging cycles. Use only the supplied battery.
• Connect the charging cable to the connecting socket on the unit and the charger plug to a suitable
power socket. For safety reasons use only the supplied charger.
• A charging battery symbol appears during the charging process when the display is activated. When the
charging process is finished, the charge status display will show 100 %.
EN-10
• Place the unit on a soft surface and open the battery compart-
ment on the back of the unit.
• Connect the plug from the battery compartment to the battery
plug. Make sure the cable colours are aligned.
• Slide the connected plug back into the designated compartment
and insert the battery. Be sure the cable is not trapped or caught
in any way.
• Close the battery compartment.
Attention! Do not remove the foil wrapping from the battery.