Furuno 1815 Operator's Manual page 15

1. INSTALLATION
1. Fix the bracket assembly to a desktop with four self-tapping screws (525, sup-
plied). Be sure to follow the recommended maintenance space show in the outline
drawing. Insufficient space may damage to the connectors when disconnecting
and reconnecting them.
2. Loosely screw knob into the bracket assembly.
3. Set the display unit to the bracket assembly.
4. Tighten the knob to fix the display unit.
5. Adjust the angle of the display unit for comfortable viewing angle.
Note: Do not tilt the unit 90-degree backward or forward. The cable connector
may be damaged if it contacts the bracket.
6. Attach the hard cover to the display unit to protect the unit when it is not in use.
Flush mount (in a console)
Select a flat mounting location and install the unit as shown below.
It is recommended to set up a dedicated breaker when flush mounting the unit, since
it will be difficult to disconnect cables.
1. Using the paper template (supplied), make a cutout in the mounting location.
2. Unfasten four washer head screws on the rear of the display unit to remove the
bracket cover and the cover sponge.
3. Set the flush mounting sponge (supplied) to the display unit.
4. Screw four threaded rods (supplied) to the display unit.
5. Set the display unit to the cutout.
6. Fasten the display unit from behind with four sets of flat washers, spring washers
and wing nuts (supplied).
1-2
Screw
Hanger cover
Cover sponge