Event; E-Mail Registration; Smtp Mode - Qtum HD1049 Installation And User Manual

5. Event

This section is used to inform the user as to an event occurring, this can be by the sounding
of a buzzer or by sending an E-mail to a predefined address.

5-1. E-Mail Registration

Within this section up to 3 users can be set-up to receive an email on the occurrence of an
event such as Video Loss / Alarm / Motion or Power Loss. An E-mail will only be sent if the
DVR is sitting on a network with access to the Internet, e.g. through a router.
The user name & e-mail address are set from the on screen keyboard via the mouse.
The Sender Address is the address that will appear on the E-mail received by the user, this
should be set logically to identify the specific DVR.
The report period is used to set how often e-mails are sent: Immediately, Daily or Weekly.
"Send Test Mail" sends a test E-mail to the addresses so allowing the installer to verify if
the setup is correct.

5-2. SMTP Mode

The default is SMTP Mode "OFF". In order to activate SMTP Mode, choose SMTP Mode
either IP or Domain first. Then, put ID, Password, Domain/IP, and port.
Finally press "SMTP Status Check" to test.
HD1049 installation and user manual
Within this section up to 3 users can be
set-up to receive an email on the
occurrence of an event such as Video
Loss / Alarm / Motion or Power Loss. An
E-mail will only be sent if the DVR is
sitting on a network with access to the
Internet, e.g. through a router.
The SMTP (Simple Mail Transfer
Protocol) function allows e-mails to be
sent over a LAN.
44