Haier HCR2250AES Installation Instructions Manual page 6

TEMPERATURE
IMPORTANT: Some cabinet and building materials are not designed to withstand
the heat produced by the oven for baking and self-cleaning. Check with your builder
or cabinet supplier to make sure that the materials used will not discolor, delaminate
or sustain other damage.
•
Contact a qualified floor covering installer to check that the floor covering can
withstand at least 200°F (93°C).
•
Use an insulated pad or 1/4" (0.64 cm) plywood under range if installing range over
carpeting.
GENERAL
•
The range should be located for convenient use in the kitchen.
•
Recessed installations must provide complete enclosure of the sides and rear of
the range.
•
To eliminate the risk of burns or fire by reaching over heated surface units,
cabinet storage space located above the surface units should be avoided. If
cabinet storage is to be provided, the risk can be reduced by installing a range
hood or microwave hood combination that projects horizontally a minimum of 5"
(12.7 cm) beyond the bottom of the cabinets.
•
All openings in the wall or floor where range is to be installed must be sealed.
•
Do not seal the range to the side cabinets.
•
Grounded electrical supply is required. See "Electrical Requirements" section.
DIMENSIONS
Product/Clearance
5.9" (15 cm)
Min.
b
4
a
30" (77 cm)
25"
Min.
(63.5 cm)
35.4"
(90 cm)
23.6"
(60 cm)
HCR2250AES
HCR2250ACS
a
24" (61 cm)
b
23.6" (60 cm)