Haier HCR2250AES Installation Instructions Manual page 17

DIRECT WIRE - U.S.A. ONLY
Disconnect power before servicing.
Improper connection of aluminum house wiring and copper appliance
leads can result in an electrical hazard or re. If the home has aluminum
wiring, only use connectors designed and UL listed for joining copper to
aluminum and precisely follow the manufacturer's recommended
procedure. Aluminum-to-Copper connections must conform with local
codes.
Use 8 gauge copper or aluminum wire.
Electrically ground range.
Failure to do so can result in death, re or electrical shock.
Be sure your appliance is properly installed and grounded by a qualified
technician. Ask your dealer to recommend a qualified technician or an authorized
repair service.
•
A circuit breaker is recommended.
•
The range can be connected directly to the circuit breaker box (or fused
disconnect) through flexible or nonmetallic sheathed, copper or aluminum cable.
•
Allow at least 6 ft (1.8 m) of slack in the line so that the range can be moved if
servicing is ever necessary.
•
A UL listed conduit connector must be provided at each end of the power supply
cable (at the range and at the junction box).
•
Wire sizes and connections must conform with the rating of the range.
•
The tech sheet and wiring diagram are included with the range.
This appliance is manufactured with a green GROUND wire connected to the range
chassis. After making sure that the power has been turned off, connect the flexible
conduit from the range to the junction box using a UL listed conduit connector. The
Grounded Neutral and Ungrounded Neutral Graphics on the following pages and the
instructions provided, present the most common way of connecting the range. Your
local codes and ordinances, of course, take precedence over these instructions.
Complete electrical connections according to local codes and ordinances.
WARNING
Electrical Shock Hazard
15