Intelliph Installation; Setting Up The System For The First Time; Operation With Intellitouch And Easytouch Automation Systems - Pentair INTELLIpH Installation And User Manual

IntellipH

Setting up the system for the first time

For best operation, the IntellipH
your basic acid needs. Perform the following steps to setup the system:
• Use a Test Kit to balance the pool water
• Measure the water pH
• Operate the IntellipH Acid Dispenser system for one week
• Monitor the pH regularly and adjust the acid dispensing amount using the
"More" or "Less" buttons as required.
Operation with IntelliTouch
When the IntellipH Controller is connected to an IntelliTouch
System, the IntellipH Controller monitors the communication link between the IntelliChlor
SCG and the Control System.
When the IntelliChlor SCG is connected to a Control System, the cell sanitizer output
will be adjusted through the automation panel menu and NOT from the IntelliChlor SCG
control panel. The "MORE and LESS" buttons on IntelliChlor SCG are disabled.
If the Control System sends out a 0% output command to the IntelliChlor SCG, the cell
output percentage display will be blank which indicates no chlorine is being produced.
The IntellipH dispenser will display SYSTEM OFF, WILL NOT DISPENSE. No acid will be
dispensed during this time.
If the automation panel is in SPA MODE or the IntelliChlor SCG output is set to 1% -5%,
the IntellipH Acid Dispenser will display SPA MODE, WILL NOT DISPENSE. Acid will not
be dispensed while this is displayed. This is a safety feature.
Acid Dispenser Installation
®
Acid Dispenser system should be configured to match
®
and EasyTouch
®
INTELLIPH
Control System
®
, EasyTouch
®
ACID DISPENSER Installation and User's Guide
®
7
Control
®
®