Dell OptiPlex 7050 Micro Owner's Manual page 34

C States Control
Limited CPUID Value
Intel TurboBoost
Table 10. Power Management
Option
AC Recovery
Auto On Time
Deep Sleep Control
Fan Control Override
USB Wake Support
Wake on LAN/WWAN
Block Sleep
Intel Ready Mode
34 System setup
Description
Determines how the system responds when AC power is re-applied after a power loss. You can set
the AC Recovery to:
• Power Off
• Power On
• Last Power State
This option is Power Off by default.
Sets time to automatically turn on the computer. Time is kept in standard 12-hour format
(hour:minutes:seconds). Change the startup time by typing the values in the time and AM/PM fields.
NOTE: This feature does not work if you turn off your computer using the switch on a
power strip or surge protector or if Auto Power is set to disabled.
Allows you to define the controls when Deep Sleep is enabled.
• Disabled
• Enabled in S5 only
• Enabled in S4 and S5
This option is Enabled in S4 and S5 by default.
Allows you to determine the speed of the system fan. When this option is enabled, the system fan
runs at the maximum speed. This option is disabled by default.
Allows you to enable the USB devices to wake the computer from standby mode. The option "Enable
USB Wake Support" is selected by default
This option allows the computer to power up from the off state when triggered by a special LAN
signal. This feature only works when the computer is connected to AC power supply.
• Disabled - Does not allows the system to power on by special LAN signals when it receives a
wake-up signal from the LAN or wireless LAN.
• LAN or WLAN - Allows the system to be powered on by special LAN or wireless LAN signals.
• LAN Only - Allows the system to be powered on by special LAN signals.
• LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state, that will
cause the system to wake-up and immediately boot to PXE.
• WLAN Only - Allows the system to be powered on by special WLAN signals.
This option is Disabled by default.
Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by default.
Allows you to enable the capability of Intel Ready Mode Technology. This option is disabled by default.
Allows you to enable or disable additional processor sleep states.
This option is enabled by default.
Allows you to limit the maximum value of the processor standard
CPUID function. This options is disable by default.
Allows you to enable or disable the Intel TurboBoost mode of the
processor. This option is enabled by default.