Installing Heat Sink; Processor; Removing Processor - Dell OptiPlex 7050 Micro Owner's Manual

a Loosen the M3 screws that secure the heat sink to the computer [1].
NOTE:
b Lift the heat sink away from the computer [2].

Installing heat sink

1 Place the heat sink on the processor.
2 Tighten the M3 screws to secure the heat sink to the system board.
3 Install the:
a system fan
b 2.5–inch drive assembly
c cover
4 Follow the procedure in

Processor

Removing processor

1 Follow the procedure in
2 Remove the:
a cover
b 2.5–inch drive assembly
c system fan
d heat sink
The 35 W CPU has four screws and the 65 W CPU has three screws.
After working inside your computer.
Before Working Inside Your Computer.
Removing and installing components 17