Adjusting Cutting Height; Connecting Charger To Power Supply - Stihl RMA 510 Instruction Manual

1
3
Line up the handle knobs (1) in one
N
of the three positions on the
brackets (3).
Rotate the handle knobs (1) 90° so
N
that they engage the holes in the
brackets (3).
Make sure that both handle knobs (1)
are in the same position.
Unfolding the upper handle
5
Unfold the upper handle (4).
N
Tighten down the star knobs (5)
N
clockwise.
RMA 510

Adjusting Cutting Height

Different cutting heights can be
selected.
Setting
90°
1
2
3
4
5
6
7
Adjusting Cutting Height
4
To incerase cutting height:
Pull cutting height adjustment
N
lever (1) toward rear of mower.
Reduce cutting height:
Pull cutting height adjustment
N
lever (1) toward front of mower.
The selected cutting height is shown.
Cutting
height
35 mm (1.4 in)
43 mm (1.7 in)
52 mm (2 in)
60 mm (2.4 in)
71 mm (2.8 in)
79 mm (3 in)
90 mm (3.5 in)
1
Connecting Charger to
Power Supply
Power supply (mains) voltage and
operating voltage must be the same.
Insert the plug (1) in the wall
N
outlet (2).
1
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
English
2
1
17