Operating Instructions - Porter-Cable PCX18604P-12A/8101261 Owner's Manual

OPERATING INSTRUCTIONS

UNPACKING & SET-UP SUMMARY
1 .Pull lid latches in an outward motion, remove power head and some accessories that
may have been shipped in the tank.
2 .Attach caster dolly following the instructions in this manual.
3.Before replacing power head, refer to this manual to ensure you have the proper filters
installed for your cleaning operation.
4.Replace power head, and apply pressure with thumb to each latch until it snaps tightly
in place. Make sure all lid latches are clamped securely.
5.Insert the flexible hose end into inlet of tank.
6.Attach the extension wands to the accessor end of the hose. Apply slight pressure until
fitting is tight.
7.Attach one of the cleaning accessories (depending on your cleaning requirements) on
the extension wands. Twist slightly to tighten the connection.
8.Plug the cord into the wall outlet. Your cleaniner is ready for use.
CASTER / ACCESSORY HOLDER ASSEMBLY
1.Invert dust tank, take the dolly to align the tank bottom sinking
place. Secure with screws provided.
2.Return dust tank assembly upright.
WARNING!
To reduce the risk of fire or explosion, do not operate this vacuum in areas with
flammable gases, vapors or explosive dust in the air. Flammable gases or vapors
include but are not limited to: lighter fluid, solvent-type cleaners, oil-based paints,
gasoline, alcohol or aerosol sprays. Explosive dusts include but are not limited to: coal,
magnesium, aluminum, and grain or gun powder. Do not vacuum explosive dust,
flammable or combustible liquids or hot ashes. Do not use this vacuum as a sprayer for
any flammable or combustible liquid. To reduce the risk of health hazards from vapors
or dusts, do not vacuum toxic materials.
WARNING!
The operation of any utility vacuum can result in foreign objects being blown into the
eyes, which can result in severe eye damage. Always wear safety eyewear complying
with ANSI Z87.1 (or in Canada, CSA Z94.3) before starting operation.
CAUTION:
To reduce risk of hearing damage, wear ear protectors when using the vacuum for
extended hours or when using it in a noisy area.This 12-gallon wet/dry
vacuum is assembled at the factory and ready for use when you remove it from the
carton. The unit is ready for dry vacuuming or blowing. After you plug the power cord into
the wall receptacle, turn the unit "ON" by pushing the switch from
position "O" to position "I". The "O" is the "OFF" position and the
"I" is the "ON" position.
O = OFF I = ON
6