Download Print this page

Steam Cleaning - Fakir nilco DS 34 Instructions For Use Manual

Advertisement

Available languages

Available languages

Abb,
A
Release canister clamps and remove motor head.
O
Push the foam filter on to the float valve retainer as far as it will go.
C 2
Place the water tank into canister.
J
Fill in a maximum of 4,5 litres of tap water or distilled water.
M
Insert the waater suction hose with filter into the opening of water tank ...
D
... place the motor head on the canister and fasten the canister clamps.
E
Insert the suction hose into the opening of the canister and turn it to the right.
N
Insert the quick release coupling at the end of the hose into the mating socket in
the hood and push it home so that it locks.
F
The two suction tubes can be connected by lightly pushing. The tube can be
connected by lightly pushing on the handle. ...
G
... then safe it.
H
The floor nozzle with ...
I
... units can be connected by lightly pushing on the tube ...
G
... then safe it.
You can also use the:
Window pane nozzle (position 19 - page 4) or the
steam spray jet with round brush (psition 14+15 - pagee 4):
P 2
Unwind the mains lead and install the plug into the power socket. Switch on the
heating by pressing the switch to ON psosition. ...
Q 2
... until the "steam ready" indicator lights up.
Important: During steam formation, the pump may suck in air bubbles and cause
"lack of water" warning light Q 1 to light up. This condition is normal when the unit
is turned on and will disappear after the steam system has operated for a few
minutes. The pilot lamp is off as soon as the valve on the handle for steam on is
opened
R 2
Steam is switched on and off by pressing the switch on the handle of the steam
pipe.
Steam ON:
Steam OFF:
P 1
Switch on the wet cleaner by pressing the switch to ON psosition.
Q 1
Important: Once all the water has been used, this is indicated by "lack of water"
warning light. In addition, the heating is switched off auatomatically > add more
water !
Important: A little water may come out of the device until the steam pipe, exten-
sion pipes and the accessory parts beeing used have warmed up. Wipe this con-
densation away with a cloth.
18

Steam cleaning

press switch and hold
release switch

Advertisement

loading