ABB aquamaster Quick Reference Manual page 16

...WIRELESS COMMUNICATIONS
Using AquaMaster to change a SIM's Access
Lock status
This requires that the PIN has already been
configured.
Cycle though options via menu item SIM Access
Lock [>367]. Using the command line, this can be
set to value 0 for 'Lock Disabled' or 1 for 'Lock
Enabled'.
[If the AquaMaster does not have a PIN to use, it
will not be able to request the SIM Access Lock
status and this will be reported as '–' or value 2.]
Using AquaMaster to unlock SIM when a PUK is
needed
If a SIM has been 'locked out' through repeated
attempts to access with an incorrect PIN then the
GSM Module Status will report 'Waiting PUK' or a
similar message. The required PUK can be
obtained from the SIM's service provider.
1. Change SIM Password using format:
<puk>,<newpin>
2. The new PIN can be seen in SIM Password.
3. The GSM module will be re-booted (takes
approx. 1 minute). Once it has rebooted, the
GSM Module Status should report that the
module is 'Ready'.
Note. The SIM password cannot be
changed via Remote port.
14
Auto Reports
This feature sends information via SMS text
messages from an AquaMaster to a programmed
number on a regular schedule. The Base Time and
Day used for the scheduling are the same as those
used for the WakeUp system.
Other control parameters are located in Menu 13:
Auto Report Phone No 1 (or 2 or 3)
AutoReport SMS text messages can be sent to
any one of three SMS telephone numbers,
designated as Auto Report Phone No 1, Auto
Report Phone No 2 and Auto Report Phone No 3.
Telephone numbers should be entered as they
would normally be dialled, with no spaces, using
either the full international
+441453123456 or 00441453123456) or the area
code and number (01453123456) as appropriate.
Each type of Auto Report has its own section of
the menu for configuration and can be sent to
either the same number or to different numbers.
These are selected by the Destination parameter
in each section as Phone No. 1, Phone No. 2 or
Phone No. 3.
Text Auto-Reports
The AutoReport message is defined in AR
Command String [>363]. This uses commands
from the AquaMaster's
command set.
e.g.: >363=TON;TFA;
This sets up AutoReport to send the Net Total and
the Tariff A Total.
format (e.g.
Parameter Access