To Turn Off; To Resume; To Vary The Speed Setting - Jeep Grand Cherokee SRT 2017 Owner's Manual

288 STARTING AND OPERATING

To Turn Off

The system will turn off and clear the set speed in memory
if:
• The Adaptive Cruise Control (ACC) on/off button is
pushed.
• The Normal (Fixed Speed) Cruise Control on/off button
is pushed.
• The ignition is turned OFF.
• You switch to Four-Wheel Drive Low.

To Resume

If there is a set speed in memory push the RES (resume)
button and then remove your foot from the accelerator
pedal. The instrument cluster display will display the last
set speed.
NOTE:
• If your vehicle stays at standstill for longer than two
seconds, then the system will cancel and the brake force
will be ramped-out. The driver will have to apply the
brakes to keep the vehicle at a standstill.
• ACC cannot be resumed if there is a stationary vehicle
in-front of your vehicle in close proximity.
WARNING!
The Resume function should only be used if traffic
and road conditions permit. Resuming a set speed that
is too high or too low for prevailing traffic and road
conditions could cause the vehicle to accelerate or
decelerate too sharply for safe operation. Failure to
follow these warnings can result in a collision and
death or serious personal injury.

To Vary The Speed Setting

To Increase Speed
While ACC is set, you can increase the set speed by
pushing the SET + button.
The driver's preferred units can be selected through the
instrument panel settings if equipped. Refer to "Getting To
Know Your Instrument Panel" for more information. The
speed increment shown is dependant on the chosen speed
unit of U.S. (mph) or Metric (km/h):