Installation Instructions; Unpacking; Location Requirements; Electrical Requirements - Whirlpool WHA30 Use & Care Manual

Unpacking

Excessive Weight Hazard
Use two or more people to move and install the
freezer.
Failure to do so can result in back or other injury.
Remove packing materials
• Remove straps and residues from surfaces before
turning your freezer on. Clean with sponge or cloth
soaked into warm water and mild detergent.
Rinse and dry well with a clean, dry cloth.
• Do not use sharp objects, alcohol, flammable or
abrasive cleaners. These products can damage the
paint of your freezer. For further information, refer to
"Freezer safety".
Moving the freezer:
The freezer is heavy. When moving the freezer for
cleaning or maintenance purposes, make sure to
protect the floor with cardboard or another protection
no to damage it. Always move the freezer in a
straight line. Do not waggle it as that may damage
the floor.
Clean before use
After removing all packaging material, clean the freezer
inside before using it. Refer to "Taking care of the
freezer".

Location requirements

Explosion Hazard
Keep flammable materials such as gasoline away
from freezer.
Failure to do so can result in death, explosion,
or fire.

Installation instructions

1. Keep flammable materials such as gasoline away
2. Before installing the freezer, check whether the floor is
3. Level the freezer from side to side and from back to
4. Allow at least 7.5 cm (3")
5. It is not necessary to
remove the lid during
installation. If hinges need
to be adjusted, contact
the After-Sales Service.
NOTE: Do not place bedspread, sheets, towels etc. on the
freezer as they reduce air circulation.

Electrical requirements

Before installing your freezer, ensure the electrical wiring
is adequate.
13
from the freezer. Do not install it next to heat
sources.
sturdy enough to withstand its weight and that of a full
load of food.
front so that the lid closes properly. If necessary, use
wedges to level the freezer.
on both sides of the freezer
and 5 cm (2") on the back,
between the wall and the
freezer. Also, allow some
room above the freezer to
open the lid.
Electrical Shock Hazard
Connect the ground wire to an effective ground.
Do not remove ground wire.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire or electrical shock.
2" (5 cm)
3" (7.5 cm)