Advertisement
OPERATING INSTRUCTION
This model is novel and attractive with luxurious appearance, reasonable features, and
easy operation. It has both fan and humidi er functions blowing cool mist that may be
used together or separately. This fan uses ultrasonic vibration components, atomizes the
water to 1 - 5 micron particles and spreads the mist into the air through the wind. This
function increases the cool humidity which makes you feel cool in a single room or in the
entire home.
FAN OPERATION
Set the fan base on a dry, level surface. Plug cord
into any standard 120 volt AC outlet, the indicator
light
on the control panel (Figure 4) will be lit.
The fan is ready for use and can be controlled by
using the remote control or the buttons on the
control panel on the fan body.
1. Press "ON/SPEED" button to turn on the fan and to
choose the wind speed: Low, Medium or High. The LED screen on the control panel will
indicate the fan speed selected.
2. Press "PIVOT" button to change the wind direction, meanwhile the corresponding light
will be lit. Press this button again to stop oscillation.
3. Press "WIND" button to choose the wind type, meanwhile the corresponding light will be l
lit.
"Normal": Wind blow based on Low/Medium/High speed.
"Natural": Imitates the natural uctuations in speed of wind.
"Sleeping": In the rst half an hour, the fan runs as strong and soft natural wind, and
then it becomes medium natural wind in the second half an hour. After the hour, it
changes to soft natural wind until the end of preset time.
4. Press "TIMER" button to set the timer function. This fan is equipped with an automatic
shut off feature. To select desired length of operation hours, press the Timer Button a
number of times until the LED displays the desired operation time (from 1 hour to 7 hours,
in 1-hour increments).
5. Press "MIST" button and the corresponding light will be lit. Mist will spread out of the
front mist plate.
6. Press "FAN STOP" button, it switches off the fan and all fan functions return to initial
condition.
REMOTE CONTROL (Figure 5)
The remote control must be directed at the infrared port on the fan
body. If the remote control does not operate well, please check the inside
batteries rst, and change with new batteries if needed. Your remote
control uses two (2) "AAA" batteries (not included) for operation.
Notes: Change the batteries with new and same types. Otherwise your
remote control may not operate properly. Remove the batteries out of the
remote control if you won't use the remote control for a long time.
Remaining batteries may damage your remote control.
61401-01 20150202
6
Figure 4
Figure 5
Advertisement
