Advertisement
OPERATING INSTRUCTIONS(CONT.)
WATER TANK
Stabilize the mist fan on the ground and add water into the water tank according
to the six steps below:
Note: Remove and discard the protective foam on the
top of the water tank during the rst use.
Important: Do not take out the water tank before
unplugging the power cord. Do not add hot water
(104°F / 40°C or above) into the tank.
1. Loosen the locking screw on the water tank panel.
Open the panel. Figure 6.
2. Lift the water tank. Figure 7.
3. Take out the water tank horizontally. Figure 8.
4. Put the water tank base up. Figure 9.
5. Screw off the tank cap and add water. Then screw
back the tank cap. Figure 10.
6. Put the water tank back into the fan, then close the
water tank panel and tighten with the locking screw.
Figure 11.
Important: Remember to tighten back the
locking screw on the water tank panel after
adding water to the water tank.
61401-01 20150202
7
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Advertisement
