Notice This signal word indicates important information (e.g. material damage), but does not indicate hazards. Info Information marked with this symbol helps you to carry out your tasks quickly and safely. Operating manual – designer glass convector TCH 2000 E...
• Make sure that the air inlet and outlet are not obstructed. • Do not place the device on combustible ground. • Allow the device to cool down before transport and / or maintenance work. Operating manual – designer glass convector TCH 2000 E...
Page 4
Warning of hot surface Parts of this appliance can become very hot and cause burns. Particular attention is to be paid when there are children or vulnerable persons present! Operating manual – designer glass convector TCH 2000 E...
Information about the device Device description The designer glass convector TCH 2000 E is used to generate warm air for interior spaces. The device generates heat by means of an electric heating element. The air surrounding the heating element is heated. The heated air rises through the air outlet and thus creates a natural suction that makes the cold room air flow into the device.
1. Open the cardboard box and take the device out. 2. Completely remove the packaging. 3. Fully unwind the power cable. Make sure that the power cable is not damaged and that you do not damage it during unwinding. Operating manual – designer glass convector TCH 2000 E...
• Do not install the device directly below a wall socket. • Never install the device in a way that it radiates directly onto walls or other objects. • Only install the device in a horizontal position. Operating manual – designer glass convector TCH 2000 E...
Page 8
6. Fasten the wall holder (7) to the wall. 8. Push the catch (8) into the device. Make sure that the catch engages with the device. 9. Fasten the screw at the lock (8) and check it for tight fit. Operating manual – designer glass convector TCH 2000 E...
Page 9
• Make sure that no curtains or other objects interfere with the air flow. • Do not position the device directly below a wall socket. • Make sure that the device cannot come into contact with moisture or water. Operating manual – designer glass convector TCH 2000 E...
The display comes with a blue background illumination. The background illumination switches on as soon as one of the control panel buttons is pressed. After approx. 15 s without any input, the background illumination switches back off. Operating manual – designer glass convector TCH 2000 E...
Page 11
The heating 1 indication (13) is no longer framed and the heating 2 indication (14) goes out. If the determined room temperature falls below the desired room temperature by 5 °C, the heating switches back to economy heating mode. Operating manual – designer glass convector TCH 2000 E...
Page 12
Notes regarding automatic switch-off: 5. Store the device according to the Storage chapter. • Manually switching the device off disables the automatic switch-off function. • If you select 0 hours, the timer will be off. Operating manual – designer glass convector TCH 2000 E...
(length x width x height) Trotec for repair. Plug type CEE 7/7 Minimum distance to walls and other objects A: top: 60 cm B: rear: 30 cm C: side: 30 cm D: front: 30 cm Operating manual – designer glass convector TCH 2000 E...
Page 15
Spare parts drawing and list Info The position numbers of the spare parts differ from those describing the positions of other parts mentioned in this operating manual. Operating manual – designer glass convector TCH 2000 E...
You are responsible for deleting any personal data stored on the waste equipment to be disposed of. Operating manual – designer glass convector TCH 2000 E...
Page 18
Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...