Data Ports, Comm Port Baud Rate; Remote Control Codes - McIntosh D1100 Owner's Manual

Data Ports
Data Ports Connections between the D1100 and a
McIntosh Source Component, allow for basic func-
tion control of the source component using the D1100
supplied HR085 Remote Control. By default, all of the
four Data Ports are set to send the same Data to the
selected source. To dedicate a given Data Port for only
one source component (example, source component
connected to the OPTI 1 (MEDIA SERVER) Input
will be assigned to Data Port 1) perform the following
Steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until "SETUP: Data
Ports, (Hold INPUT)" appears on the Information
Display. Refer to figure 39.
SETUP: Data Ports
(Hold INPUT)
Figure 39
3. Press and hold in the INPUT Control until "SET-
UP: DATA PORT 1, All Data" appears on the
Display. Refer to figure 40.
SETUP: DATA PORT 1
All Data
Figure 40
4. Rotate the VOLUME (ADJUST) Control to select
"OPTI 1" Input. Refer to figure 41.
SETUP: DATA PORT 1
OPTI 1
Figure 41
5. In a similar manner, perform steps 3 and 4 to as-
sign any additional Data ports.
6. Exit the SETUP Mode by several presses of the
INPUT Control.
Comm Port Baud Rate
The D1100 may be remotely controlled from other
equipment connected to the Rear Panel RS232 Jack.
The speed at which the D1100 communicates (8 bit, no
parity and 1 stop bit) with other equipment is adjust-
able from 9,600 bits per second to 115,200 bits per
second. To change from the default speed of 115,200
bits per second, perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until "SETUP: RS232,
115200 Baud" appears on the Information Dis-
play. Refer to figure 42.
SETUP: RS232
115200 Baud
Figure 42
3. Rotate the VOLUME (ADJUST) Control to select
the desired Baud Rate Speed.
4. Exit the SETUP Mode by several presses of the
INPUT Control.

Remote Control Codes

The Remote Control included with the D1100 utilizes
the NORMAL McIntosh Control Codes. The Second
Set of Control Codes the D1100 will respond to is
referred to as the ALTERNATE Codes. The Alternate
Codes are used when the D1100 is used in the same
location as another McIntosh Preamplifier and/or A/V
Processor. This will prevent the Remote Control from
affecting the operation of both units at the same time.
To activate the Remote Control ALTERNATE Codes
perform the following steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until "SETUP: IR
Codes, Normal" appears on the Information
Display. Refer to figure 43.
SETUP: IR Codes
Normal
Figure 43
3. Rotate the VOLUME (ADJUST) Control to the
Alternate Codes. Refer to figure 44.
SETUP: IR Codes
Alternate
Figure 44
4. It is now necessary to change the HR085 Remote
Control over to the Alternate Codes. Information
on the HR085 Remote Control is available for
download from the McIntosh Web Site:
http://www.mcintoshlabs.com/us/Products/pages/
ProductDetails.aspx?CatId=preamplifiers&Produ
ctId=D1100
5. Exit the SETUP Mode by several presses of the
INPUT Control.
Setup, con't
17