ABB ACS850-04 Hardware Manual page 23

Task
Check the installation site. Fasten the base of the
cabinet to floor.
Route the cables.
Check the insulation of the supply cable, the motor
and the motor cable and the resistor cable (if present).
Units with optional cabling panels (+H381 or +H383)
• Install the cabling panels into the cabinet.
• Install the additional components into the cabinet
(composition varies, for example: main disconnector,
main contactor, main AC fuses, etc.).
• If the main disconnector is installed into the cabinet,
connect the input power cabling to it.
• Connect the input power cables and motor cables to
the cabling panel terminals.
• Connect the brake resistor and DC connection
cables (if any) to the cabling panel terminals.
• Install the drive module into the cabinet.
• Fasten the cabling panel busbars to the drive module
busbars.
• If external drive control unit, connect the power
supply and fiber optic cables from the drive module to
the control unit and install the control unit into the
cabinet.
Units without optional cabling panels (no +H381 or
+H383)
• Install the additional components into the cabinet
(composition varies, for example: main PE busbar,
main disconnector, main contactor, main AC fuses,
etc.).
• Install the drive module into the cabinet.
• Connect the power cabling between the drive module
and the rest of the main circuit components in the
cabinet (if any).
• Connect the input power cables and motor cables to
the drive cabinet.
• Connect the brake resistor and DC connection
cables to the drive cabinet.
• If external drive control unit, connect the power
supply and fiber optic cables from the drive module to
the control unit and install the control unit into the
cabinet.
See
Checking the installation site
Ambient conditions (page 134)
Planning the cabinet installation
Routing the cables (page 60)
Checking the insulation of the assembly
76)
Installing the mechanical accessories into the
cabinet (page 79)
Connecting the power cables
Mounting the drive module into the cabinet
(page 89)
Connecting the external control unit to the drive
module (page 97)
Mounting the external control unit
Manuals for any optional equipment
Introduction to the manual
23
(page 73)
(page 37)
(page
(page 84)
(page 99)