Table of Contents
Advertisement
System Configuration
2.4 Pin Swap Cable
A single PLM + amplifier can drive up to 8x S10 enclosures, so long as the NL803 Pin Swap Cable
(920-0024) is utilized. This cable is marked with red heat shrink to distinguish it from other NL8
links in a user's inventory.
Pins 1 & 2 are switched with pins 3 & 4 in this cable, allowing S10 users to load all output channels
of a Lab.gruppen PLM + amplifier. Here is an example of how to configure the outputs in Lake
Controller to make use of this cable:
Since the PLM + amplifiers offer four
DSP modules, recalling 2x LF and 2x
HF modules will allow for greater zone
control in an S10 array.
Page 15
Advertisement
Table of Contents
Need help?
Do you have a question about the S-SERIES and is the answer not in the manual?