Table of Contents
Advertisement
RENAME: BAL 1
>MEDIA BR
Figure 16
RENAME: BAL 1
>MEDIA BRD
Figure 17
RENAME: BAL 1
>MEDIA BRDG
Figure 18
19. To save the new name, press and hold in the SET-
UP Push-Button until "SETUP: MEDIA BRDG ,
ON / Rename" appears on the Front Panel Infor-
mation Display. Refer to figure 19.
SETUP: MEDIA BRDG
On / Rename
Figure 19
21. Exit the SETUP Mode by pressing the SETUP
Push-button.
Note: For convenience, an "Input Assignment
Chart" on a separate sheet "Mc5A/5B" has
been provided to keep track of changes.
Output Settings
The Output Settings provide the ability to change how
the C1100 Output 1 and Output 2 function.
OUTPUT 1 and 2:
By defaut OUTPUT 1 and 2 are set to go On/Off by
using the Front Panel TRIM and ADJUST Controls
or the OUTPUT 1 and 2 Push-buttons on the Remote
Control. If it is desirable to have OUTPUT 1 and/or
2 always On regardless of the TRIM setting, perform
the following:
20
1. Press the SETUP Push-button to enter the SETUP
MODE. Refer to figure 2, on page 18.
<
2. Rotate the TRIM Control until "SETUP: OUT-
PUT 1, Switched" appears on the Information
Display. Refer to figure 20.
SETUP: OUTPUT 1
<
3. Rotate the ADJUST Control until "SETUP:
OUTPUT 1, Unswitched" appears on the Informa-
<
tion Display. Refer to figure 21.
SETUP: OUTPUT 1
4. In a similar manner, perform steps 2 and 3 to
change the OUTPUT 2 setting. Refer to figures 22
and 23.
SETUP: OUTPUT 2
SETUP: OUTPUT 2
5. Exit the SETUP Mode by pressing the SETUP
Push-button.
Switched
Figure 20
Unswitched
Figure 21
Switched
Figure 22
Unswitched
Figure 23
Headphone Settings
The C1100 has the ability to automatically mute the
Output Jacks and/or Connectors when a Headphone
Cable Plug is inserted into the C1100T Front Panel
HEADPHONES Jack. The Output Default Settings
are:
MAIN - Unmuted
OUTPUT 1 - Muted
OUTPUT 2 - Muted
In the following examples the MAIN Output Jacks
will Mute and the OUTPUT 1 Connectors will not
Mute when Headphones are connected:
1. Press the SETUP Push-button to enter the SETUP
MODE. Refer to figure 2, on page 18.
2. Rotate the TRIM Control until "SETUP: MUTE
WITH HDPH, Main = Unmuted " appears on the
Information Display. Refer to figure 24.
SETUP:MUTE WITH HDPH
Main = Unmuted
Figure 24
3. Rotate the ADJUST Control to change the current
setting to "SETUP: MUTE WITH HDPH, Main =
Muted". Refer to figure 25.
SETUP:MUTE WITH HDPH
Main = Muted
Figure 25
4. Rotate the INPUT Control to change the current
setting to "SETUP: MUTE WITH HDPH, Output
1 = Muted". Refer to figure 26.
SETUP:MUTE WITH HDPH
Output 1 = Muted
Figure 26
Advertisement
Table of Contents
