McIntosh C1100 Owner's Manual page 28

How to Operate the C1100, con't
After approximately 10 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
Notes: 1. Meter Illumination of recent McIntosh Power
Amplifiers will also switch On/Off when
connected to the C1100 via a power control
cable.
2. Some A/V Processors will provide an On/
Off Control Signal when the C1100 Passthru
Input Jack is connected to the A/V Processor
via the power control cable.
28
INFORMATION DISPLAY ILLUMINATION
The Brightness Level of C1100 Front Panel Informa-
tion Display can be adjusted from bright to dim by
performing the following:
1. Select "DISPLAY BRIGHTNESS" as indicated
on the Front Panel Information Display. Refer to
figures 60, 63 (on page 26) and 77.
DISPLAY
BRIGHTNESS
Figure 77
Figure 60
Figure 76
2. Reduce the Brightness level by adjusting the
TRIM LEVEL. Refer to figure 78.
DISPLAY
BRIGHTNESS
Figure 78
After approximately 10 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
PHONO ADJUSTMENTS
When the Phono MC or Phono MM Input is selected
an additional TRIM SELECT FUNCTION becomes
available for adjustment. Perform the following steps
to make the Phono Trim Adjustments:
1. Select either the Phono MM or Phono MC Source
Input.
2. Select "MC PHONO LOAD, 400Ω (ohms)" or
"MM PHONO LOAD, 50pF" as indicated on the
Front Panel Information Display. Refer to figures
79 and 80.
MC PHONO LOAD
400O
Figure 79
MM PHONO LOAD
50pF
Figure 80
3. Set the desired phono cartridge loading value
(Ohms for a Moving Coil Cartridge or Capaci-
tance for a Moving Magnet Cartridge) that comes
closest to the Phono Cartridge Makers recom-
mended value.
After approximately 10 seconds the Alphanumeric