Troubleshooting - GE AF-600 Installation And Start-Up Instructions Manual

6. Troubleshooting

Drive1 and Drive2 Motor Rotation
If careful attention to phase rotation is not made during connection of the panel to the three-phase power
supply and motor, then there is only a one chance in four that the motor will rotate correctly in both drive1
and drive2 modes.
The other three possibilities and the corresponding corrective actions are as follows:

Problem: Motor turns correctly in Drive2 mode and incorrectly in Drive1 mode.
Solution: Swap the leads at the drive's output terminals.

Problem: Motor turns correctly in Drive1 mode and incorrectly in Drive2 mode.

Solution: Swap the leads at the drive's output terminals.

Problem: Motor turns incorrectly in both modes.
Solution: Swap the leads at the motor leads on the contactor's output terminals.
Drive Fault Codes
Refer to FP troubleshooting guide.
DEH40634
17
AN 11-1018 Rev.02, 09/26/2011