Table of Contents
Advertisement
Pause/Stop:
• Press "STOP" button once or first page button on the screen, the belt will slow down gradually till
fully stop and keep values of time, distance and calorie on the screen. The screen will reset after 5
minutes of counting down then return to the previous status.
• Press "START" button to continue the workout during pause.
• Press "STOP" button twice will terminate the setting with displaying the workout summary. If "STOP"
button is pressed the third time, the console will return to the initial status (the beginning).
Incline:
The incline is changeable any time during the workout.
•
• Press and hold "UP" or "DOWN" button or Incline +/- button on the screen to change the incline to
the desired level.
Heart rate testing feature:
Pulse (heart rate) on the screen shows the current value of the heart beats per minute. You must hold
both left and right stainless steel sensors to test the pulse. The pulse value will be shown on the
screen continuously. You can also use hand pulse sensors for heart rate control. The console can
also detect the pulse from heart rate stripe which is bipolar including signal transmitting.
To turn off the treadmill:
The screen will turn it off (sleep status) when there is no command within 30 minutes. This is called
sleeping mode and the treadmill will stop most of its activity except the minimum circuit detecting
system for press buttons so that when there is any button activation, the treadmill restarts. There is
only very little electric current (like a TV turned off) in the sleeping mode. It is fine to leave the main
power switch on during sleeping mode.
-13-
Advertisement
Table of Contents
