Installation - Alpine CDM-7857RB Owner's Manual

Installation

1
Bracket
Dashboard
Mounting sleeve
(Included)
Remove the Detachable Front Panel (refer to
page 4). Slide mounting sleeve from main unit
(see Removal Procedure below). Slide the
mounting sleeve into the dashboard.
2
Metal Mounting Strap
Hex Nut (M5)
When your vehicle has the Bracket, mount the
long hex bolt onto the rear panel of the CDM-
7857RB/CDE-7855RB/CDE-7854RM/CDE-
7854R/CDE-7853R and put the Rubber Cap on
the hex bolt. If your vehicle does not have the
Mounting Support, reinforce the head unit with
the metal mounting strap (not supplied). Connect
all the leads of the CDM-7857RB/CDE-7855RB/
CDE-7854RM/CDE-7854R/CDE-7853R
according to details described in the
CONNECTIONS section.
NOTE
For the screw ∗, provide a proper screw to the chassis
installing location.
Rubber Cap
(Included)
Hex Bolt
(Included)
CDM-7857RB/CDE-7855RB/
CDE-7854RM/CDE-7854R/
CDE-7853R
Screw
Bolt Stud
∗
CDM-7857RB/CDE-7855RB/
CDE-7854RM/CDE-7854R/
CDE-7853R
3
Slide the CDM-7857RB/CDE-7855RB/CDE-
7854RM/CDE-7854R/CDE-7853R into the
dashboard. When the unit is in place, make sure
the locking pins are fully seated in the down
position. This can be done by pressing firmly in on
the unit while pushing the locking pin down with a
small screwdriver. This ensures that the unit is
properly locked and will not accidentally come out
from the dashboard. Install the Detachable Front
Panel.
Lock pin
Removal
1 Remove the detachable front panel.
2 Use a small screwdriver (or similar tool) to
push the locking pins to the "up" position (see
Fig. 3). As each pin is unlocked, gently pull out
on the unit to make sure it does not re-lock
before unlocking the second pin.
3 Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Front frame
CDM-7857RB/CDE-7855RB/
CDE-7854RM/CDE-7854R/
CDE-7853R
Screws (M5 × 8)
(Included)
Mounting Bracket
17
-EN