Resuming Operation - Panasonic CF-47 Series Reference Manual

Suspend/Hibernation Functions
CAUTION
At the "beep*" sound, release your finger from the sleep switch. If you continue
to press down on the switch and hold it for more than four seconds, the unit will
emit a 2nd "beep*" then power off. Data not previously saved will be lost.
Slide the power switch to power on. Pressing the sleep switch, even if [Sleep
Switch] is set to [No Action] in the Setup Utility, will not power on the unit.
If the computer will not be operated for an extended period of time, it is recom-
mended that hibernation mode be used instead of the suspend mode.
NOTE
With the method below, you can shut down the computer by using the suspend
function.
Fn + F7 (

Resuming Operation

If the security indicator (
This password has been set in the Setup Utility and is not an NT password.
CAUTION
After the display returns, the computer needs a short period of time to reinitialize.
This takes about 15 seconds. Do not shut down or restart Windows, or use the
suspend or hibernation functions again during this time, as this may subse-
quently cause Windows to operate abnormally.
Do not install or remove peripherals while your computer is in the suspend or
hibernation mode; abnormal operation may result.
When operation resumes, serial devices such as a mouse, modem or PC Cards
may not function properly. In such cases, you will need to restart your computer
or reinitialize the individual devices.
Do not use the suspend or hibernation function when using the network func-
tion.
Avoid the following until the power is completely turned off when turning off the
computer by using the suspend or hibernation functions, or resuming operation
by pressing the sleep switch from the suspend or hibernation.
• Touch the keyboard (excluding password input), touch pad, or power switch.
• Connect the AC adapter.
• Close the display.
page 2)
Press the sleep switch
or
Slide the power switch
) is displayed, your password has been set.
5