Table of Contents
Advertisement
SUPPORTED ON BOTH ENDS
When the log is supported on both ends, as illustrated below, cut 1/3 the
diameter from the top (overbuck). Then make the finished cut by
underbucking the lower 2/3 to meet the first cut.
When bucking on a slope always stand on the uphill side of the log, as
illustrated ibelow.
When "cutting through", to maintain complete control, release the cutting
pressure near the end of the cut without relaxing your grip on the chainsaw
handles. Don't let the chain contact the ground. After completing the cut,
wait for the saw chain to stop before you move the chainsaw. Always stop the
motor before moving from tree to tree.
21
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
Advertisement
Table of Contents
