Using The Chainsaw; Personal Protective Equipment; Connecting To The Power Supply - Clarke CECS405C Operation & Maintenance Instructions Manual

USING THE CHAINSAW

WARNING: DO NOT START THE CHAINSAW UNTIL IT IS FULLY ASSEMBLED
AND ADJUSTED AND YOU HAVE READ ALL RELEVANT WARNINGS / SAFETY
INSTRUCTIONS.
For 'first time' users of this type of product, we recommend that introductory
training is undertaken from an experienced person before use.

PERSONAL PROTECTIVE EQUIPMENT

The following Personal Protective Equipment (PPE) available from you local
Clarke Dealer has been designed for use with chainsaws.
• A safety helmet with mesh visor.
• Ear defenders.
• Specialist chainsaw gloves
• Trousers or chaps suitable for chainsaw use (they contain a clogging
material which stops the chain if cut).
• Safety boots with toe and shin protection.
• Close fitting hi-visibility jacket.
CAUTION: NO PPE WILL OFFER 100% PROTECTION AGAINST CHAINSAW
CUTS ESPECIALLY IF THE CHAINSAW IS USED IN A DANGEROUS MANNER.

CONNECTING TO THE POWER SUPPLY

To prevent strain on the cable during
use:
1. Make a small loop in the power
cable.
2. Put the loop through the hole in
the handle and on the hook
shown.
3. Slowly pull the loop back to
remove the slack.
4. Connect the plug to a power socket.
NOTE: We strongly recommend that this machine is connected to the
mains supply via a Residual Current Device (RCD).
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
14