Obihai OBi1000 Series User Manual page 53

OBi1000 User Guide
Figure 36: WiFi Setup screen
Available Soft Key Options:

Scan: Start a WiFi Scan of access points that are in range

Add: Manually add an access point
Table 10: Entries under WiFi Settings
WiFi Settings
Enable
OBiWiFi Setup Mode
SSID
Status
WiFi Stats
Security
Signal Strength
MAC Address
Addressing Type
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
802.1X
802.1X User Name
802.1X Password
802.1X CA Certificate
802.1X Client Certificate
WiFi Scan Results
Below is an example of the results of a WiFi Scan:
Description
Enable/disable WiFi operation
Enable/disable the OBiWiFi setup method where the phone acts temporarily as
an AP so that a computer may connect with it over WiFi and configure the WiFi
settings on the phone's Native Web Portal
If connected to an AP, this shows the SSID of the AP. Read only.
Connection status with the AP. Either "Connected" or "Disconnected". Read
only.
Shows the number of packets received, transmitted and lost on this
connection.
If connected to an AP, this shows the security method currently used to
connect to the AP. Read only.
If connected to an AP, this shows the signal strength from the connected AP.
Read only.
MAC address of this interface
IP address to use when using static IP
Subnet mask to use when using static IP
53
Copyright Obihai Technology
Example Values
Enabled
Disabled
myOfficeAP
Connected
WEP
4
9CADEFFF1234
DHCP
192.168.15.127
255.255.255.1
192.168.15.1
8.4.4.4
4.2.2.2