Table of Contents
Advertisement
Diaphragm replacement:
1 1
At the present time (March 2007),
diaphragms are not currently available,
so you will have to replace the complete
driver following the previous section
(pages 7-10). If you have received a
diaphragm, please follow the steps
below.
2 2
Follow steps 1-10 of the high frequency
driver replacement instructions, as the
driver will need to be removed in order
to access the diaphragm.
1
1
4 4
3 3
A closeup of the high frequency driver
is shown above. Four screws and star
washers need to be removed from the
driver using the phillips head screwdriver.
4 4
Keep the four screws and star washers in
a safe place.
2 2
3 3
5 5
The plate adapter and diaphragm are
easily removed from the high frequency
driver. Place the new diaphragm (part #
coming soon) and plate assembly where
the old one was. Follow the same steps
as above, but backwards 5 to 1. Power
up the SR1530 and the new diaphragm
should now be pumping out those
highs again. Sweet, you just replaced a
diaphragm!
11
Advertisement
Table of Contents
