Advertisement
Diaphragm replacement:
1 1
At the present time (January 2007),
diaphragms are not currently available,
so you will have to replace the complete
driver following the previous section
(pages 6-9). If you have received a
diaphragm, please follow the steps
below.
2 2
Follow steps 1-6 of the high frequency
driver replacement instructions, as the
horn assembly will need to be removed
in order to access the diaphragm.
1
1
4 4
- -
3 3
3 3
A closeup of the high frequency driver
is shown above. Four screws need to be
removed from the driver using the 3mm
allen wrench.
4 4
+ +
2 2
5 5
Keep the four screws in a safe place.
The diaphragm and plate adapter are
easily removed from the horn assembly.
They may not be broken down any
further. Place the new diaphragm (part
# coming soon) and plate assembly
where the old one was. Follow the same
steps as above, but backwards 4 to
1. Power up the SA1530z and the new
diaphragm should now be pumping
out those highs again. Sweet, you just
replaced a diaphragm!
10
Advertisement
