Table of Contents
Advertisement
High Frequency Driver replacement continued:
9 9
Keep the two nuts, two locking washers,
and two fl at washers in a safe place.
10
10
The high frequency driver should
easily lift right off of the horn
assembly.
1 1
1 1
11
11
This is what the high frequency
driver looks like removed from
the horn assembly. Two headless
screws need to be removed from
the driver. Pliers could help if the
screws are too tight. Turn counter-
clockwise to loosen and remove,
clockwise to tighten. Keep the two
headless screws in a safe place.
12
12
Place the new high frequency driver
(part #0010022) where the old one
was by following the same steps
as above, but backwards 11 to 1.
Power up the SR1530 and the new
driver should now be pumping out
those highs again. Fantastic, you just
replaced a high frequency driver!
10
2 2
2 2
Advertisement
Table of Contents
