LOUD Technologies SR1530 Repair Manual page 13

Amplifi er assembly replacement continued:
1 1 2 2 3 3 4 4 5 5 6 6
4 4
Here is what it looks like with the seven
cables removed from the amplifi er
assembly. Once again, each cable
must be attached to the same terminal
that it was removed from: (1) solid
yellow, (2) yellow and black, (3) solid
green, (4) green and black, (5) solid
blue, (6) blue and black, and (7) the led
PCB assembly cable (white cable next to
the blue and black cable). Do not force
cable removal or connection, although
needle-nose pliers may aid in loosening
the crimped cables.
7 7
5 5
6 6
Important:
assembly must be returned to LOUD
Technologies Inc. The address should
be on the return shipping label that
was provided with the new amplifi er
assembly. If not, the return address is at
the top of this page. Also, please write
the order number and service request
number (ex: 1046256-1203935) in big,
black, bold numbers on the outside of
the box. This helps expedite the return.
Place the new amplifi er assembly (part
#0005688) where the old one was. Follow
the same steps as above, but backwards
4 to 1. Remove the serial number from
the faulty amplifi er assembly (as shown
in the picture above) and place on the
new amplifi er assembly. Power up the
SR1530 and relish in the fact that you just
replaced an amplifi er assembly. Hats off
to you for a job well done!
The faulty amplifi er
13