Specifications; General Specifications - Sanwa mg5000 Instruction Manual

[8] SPECIFICATIONS

8-1 General Specifications

AC sensing
LCD
Sampling rate
Overload indication
Range selection
Polarity switching
Battery Monitor
Environmental
condition
Operating
temperature / humidity
Storage temperature/
humidity
Power supply
Auto Power Off
Max. power
consumption
Measurement count 1000 times (5000 V/5 MΩ measurement, 5 sec.
Dimensions & mass
Year of production
IP class
Safety standards
Average value
1200 counts
Bar graph : 36 points
DAR/PI value : 9.99
Timer : 99 : 59 (min. : sec.)
Approx. 3 times/sec.
V function : "OL" displayed with buzzer beep
Insulation function : "OL" displayed
Auto range only
Auto switching (only "−" is displayed)
4-step indication (see 4-7)
blinks at about 7.5 V or less (accuracy
no longer guaranteed)
Altitude 2000 m or below, indoor use, pollution
degree II
0-40 ºC, max. relative humidity 85 % (no
condensation)
-10-60 ºC, max. relative humidity 90 %, no
condensation (with batteries removed)
(Batteries should be removed before storage
for a long period.)
"C"-size alkaline battery 1.5 V (LR14) x 8
Power OFF in about 10 minutes after last
operation.
Approx. 18 VA (measurement at 5000 V/
approx. 1.8 MΩ)
ON/25 sec. OFF)
188(H) x 225(W) x 97(D) mm, approx. 1750 g
(batteries included)
Initial 2 digits of the main unit serial No.
indicates the last two digits of year (20**).
IP54
IEC61010-1 CAT.III 1000 V/IV 600 V
IEC61010-2-030, IEC61010-031. IEC61557-1 & 2
− 19 −