Operation; Vacuuming Dry Materials - Craftsman 125.17608 Operator's Manual

Operation

Vacuuming Dry Materials

WARNING: Be sure to read, understand and apply all the information in the
!
Important Safety Instructions section at the beginning of this operator's
manual. Do not vacuum in areas with flammable gases, vapors, or explosive
dusts in the air. Flammable gases or vapors include but are not limited to;
lighter fluid, solvent type cleaners, oil-base paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are not limited to; coal,
magnesium, grain or gun powder. To reduce the risk of health hazards from
vapors or dust, do not vacuum toxic materials.
1
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. For dry vacuuming, the cartridge filter
must be installed correctly. To verify,
please refer to Installing Cartridge Filter
on page 10.
3. Place the power head back on the
collectin tank, and secure it in place
using the latches. (Fig. 2)
4. Insert the locking end of the hose into
the vacuum port and lock in place.
Choose the desired accessory and
insert onto the end of the hose. (Fig. 3)
5. Plug the power cord into the outlet.
(Fig. 4)
6. Turn the motor on by pressing the
power switch to the 'I' (ON) position
and begin vacuuming. (Fig. 5)
7. Once you have completed vacuuming,
press the power switch to the 'O' (OFF)
position and unplug the power cord
from the outlet.
O = OFF
DO NOT USE THE CARTRIDGE FILTER
FOR LIQUID VACUUMING.
2 3
I = ON
4
4
CAUTION: Do not vacuum drywall dust,
fireplace soot or ash with standard Wet/Dry
filter. This is very fine dust which will not
be captured by the filter and may cause
damage to motor. When vacuuming fine
dust use a fine dust filter (sold separately).
7
5