Table of Contents
Advertisement
Maintenance (continued)
Installing & Cleaning Foam Sleeve Filter
1
Installing Foam Sleeve Filter
1. Verify that the power cord is
disconnected from the outlet. (Fig. 1)
2. Remove power head from collection
tank. If cartridge filter is installed,
remove as shown on page 10 "Removing
and Cleaning Cartridge Filter".
3. Carefully slide foam sleeve filter
down over the filter cage making sure
the whole cage is covered. (Fig. 2 & 3)
4. Replace the power head onto the
collection tank and secure in place.
Cleaning and Disinfecting the
Wet/Dry Vac
To keep your Wet/Dry Vac looking its best,
clean the outside with a dampened cloth,
then dry with a clean towel.
To clean the inside of the collection tank:
1. Dump debris out.
2. Wash collection tank thoroughly with
warm water and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e., waste water pick up) the collection
tank should be disinfected.
To disinfect the collection tank:
1. Pour 1 gallon of water and 1 teaspoon
chlorine bleach into the collection tank.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the collection tank.
3. Empty drum after 20 minutes. Rinse
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the collection tank.
2
3
4
Cleaning Foam Sleeve Filter
1. With the removed power head in the
upside down position, carefully
remove foam sleeve filter. (Fig. 4)
2. Use a mild soap and water solution to
wash foam sleeve filter and rinse with
clean water. (Fig. 5)
3. Allow filter to air dry before installing and
using again.
Storage
Before storing your Vac, the collection tank
should be emptied and cleaned. The cord
should be wrapped around the unit and the
hose should be stored as described in this
manual. Accessories should be kept in the
same area as the Vac so they can be
readily available. The Vac should be stored
indoors.
12
5
Hide quick links:
Advertisement
Table of Contents
