Download Print this page

GE JGHC60GEJ Use And Care Manual page 21

Microwave cooking center

Advertisement

Control Panels
Don't use sharp-edged utensils
around the control ywls.
They
might damage them.
Clean the panels with a lightly
dampened cloth. For a more
thorough cleaning, the control
knobs can be removed by pulling
them off the knob stems. DO NOT
USE cleaning sprays or large
amounts of soap and water. These
can cause problems with the
control mechanisms. Do not use
abrasive cleansers, strong liquid
cleaners or oven cleaners—they
will damage the finish.
Outer Enamel Finish
When the range is cool, wash the
enamel finish with mild soap and
w~ter or a mild abrasive cleanser
applied with a damp cloth. Rinse
the surface with clean water and
dry with a soft cloth. If you wish,
occasionally apply a thin coat of
mild cleaning wax to help protect
the finish.
There are a number of precautions
you can take to avoid marring the
surface of the range and to prevent
it from becoming dull. Don't slide
heavy pans across it. If you spill
foods with a lot of acid (tomatoes,
sauerkraut, fruit juices, etc. ) or
foods with high sugar content,
clean them up as soon as possible.
If allowed to set, these foods could
cause a dull spot. Also, no matter
how stubborn the food stain, never
use harsh abrasive cleansers. They
could permanently damage the
enamel surface.
Removable Oven Door
The oven door is removable to
make the interior more accessible
during replacement of the lamp bulb.
Open the oven door fully and
remove the two Phillips screws that
hold the door to the hinges. Then
close the door to the automatic stop
position (at about 3 inches open).
and lift the door straight up and off
the hinges. (Due to the large amount
of insulation and the construction
of the door, it is heavy. )
Note: Care should be taken not to
place hands between the spring
hinge and the
Oven door
frame as
the hinge could snap back and
pinch tlngers.
To replace the door, make sure the
hinges are in the "out" position.
Position the slots in the bottom of
the door squarely over the hinges.
Then lower the door slowly and
evenly over both hinges at the same
time. If hinges snap back against the
oven frame, pull them back out. When
the door is in position, open it fully
and insert the two Phillips screws.
NOTE: DO NOT ATTEMPT
TO REMOVE THE UPPER
OVEN DOOR.
21
i
-..

Advertisement

loading